We found this extruder to be very useful for the Diamond Hotend, as it will need additional extruding force, especially for the 3mm filament version or the E3D v6 version.
This extruder can be used for both 1.75mm and 3mm filament without changes.
All files for this geared extruder can be found on Thingiverse:
As the plastic parts for this geared extruder are 3D printet, some cleanup and modification will have to be expected. And to fit the bearings and screws some force will have to be used. But we have built several of these kits and find it managable.
Push-In fittting mount: 3/8" (9.5mm)
Push-In fitting and stepper motor is NOT included.
- Extruder body
- 2pcs springs for idler tension 4.8mm
- 3pcs 625zz bearings
- 1pcs MK7 drive gear
- 1pcs M5x40mm hex headed bolt
- 2pcs M5 nuts
- 2pcs M5 washers
- 1pcs M5x20mm bolt
- 2pcs M3x30mm bolts
- 3pcs M3x20mm bolts
- 5pcs M3x10mm bolts
- 3pcs M3 square nut
- 3pcs M3 nut
You may also be interested in the following product(s)