Temperature Controller

More Views

Temperature Controller
Excl. Tax: $12.80 Incl. Tax: $16.00
  • Buy 10 for $12.16 ($15.20 incl. tax) each and save 5%
  • Buy 25 for $11.52 ($14.40 incl. tax) each and save 10%
  • Buy 50 for $10.88 ($13.60 incl. tax) each and save 15%
  • Buy 100 for $10.24 ($12.80 incl. tax) each and save 20%
  • Buy 500 for $9.60 ($12.00 incl. tax) each and save 25%
  • Buy 1000 for $8.96 ($11.20 incl. tax) each and save 30%

Availability: In stock

In Stock

Temperature Controller. External heatbed control for Reprap 3D printer
Temperature Controller is available for purchase in increments of 1
Description

Details

This temperature controller can be used to control heating of any heatbed in conjunction with the Power Expander. Also it can be used for any other cooling / heating requirements.

 

Specifications : 

Dimensions : 48 x 40mm
Temperature control mode : ON / OFF
Temperature range : -50 - 110 ℃
Resolution : When temperature is 0.1℃ the resolution is -9.9~99.9, other temperature segment is 1℃
Control accuracy : 0.1 ℃
Hysteresis  accuracy : 0.1℃
Refresh rate : 0.5S
High temperature protection : 0-110℃
Supply voltage : DC 12V
Static current : ≤ 35MA, attract current ≤ 65MA
Output voltage : DC 12V
Output power : 10A relay (To operate a Heatbed a Power Expanded is recommended)
Measurement input : NTC (10K 0.5%) Waterproof Sensor
Environmental requirements : -10 ~ 60 ℃, Humidity 20% -85%
NTC beta value: 3900-3949K (Thanks to Jaco)

 

How to use: 

Connect the power supply and the load to the terminals.
The current temperature is displayed.
Press the SET button, the display flashes the temperature.
Press + or - to set the desired temperature. Press SET to confirm the temperature.
The LED indicator will be lit when relay is on, and the LED indicator will be off when the relay is off.
The display will show the temperature or LL if the sensor is open, HH if it's out of range or HHH if it's the High Temperature Alarm
To change settings of the Temperature Controller press and hold the SET button for 5 seconds.
Press + or - to toggle P0 - P8 settings and press SET.

Setting Description Range Factory default
P0 Cooling/Heating C/H C
P1 Hysteresis setting 0.5 - 15 2
P2 Upper limit 110 110
P3 Lower limit -50 -50
P4 Temp. correction -7 - 7C 0
P5 Delay start time 0-10min 0
P6 High Alarm 0-110C OFF

To restore to factory settings, press and hold the + and - 



Package included : 

1x Digital Temperature Control Switch
1x Waterproof temperature sensor 

You may also be interested in the following product(s)

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

This site uses cookies. By continuing to browse this site you are agreeing to our use of cookies. Find out more here.
x