RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable

More Views

RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable
Excl. Tax: $4.00 Incl. Tax: $5.00

Availability: In stock

In Stock

RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable
RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable is available for purchase in increments of 1
Description

Details

RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable

Features:


It using 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage. An insulating layer over a wide range of temperatures, up to 80 degrees. Is the common connection of thin copper wire can not match. Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one, you can use the direct plug
Board Size: Approx. 39 x 16 x 7mm / 1.54 x 0.63 x 0.28 inch
Cable Length: Approx. 70 cm / 27.56 inch

Connection Description:

Red line connecting VCC (ramps of +)
Connect the black wire GND (ramps of -)
Green Line connection SIGNAL (ramps in s)

Tips: Under normal circumstances, the system must be configured to at least three mechanical switches.

Package Included:

1 x 3D Printer Endstop Switch

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

This site uses cookies. By continuing to browse this site you are agreeing to our use of cookies. Find out more here.
x