1. Colour: Black
2. Maximum current: 25A (enhanced heat dissipation)
3. Size: about 6 x 5 x 3.1cm
4. Mounting holes: 3.2mm diameter, for M3 screws
- This module is positioned between the output of the heating bed or extruder and your electronic board as shown in the wiring diagram.
- The white connector cable is provided.
- With this additional module, the maximum current on the board can reach 25A.
- This module is recommended if you plan to use a heated bed with a 3D printer that uses a 12V power supply.
Simple - 1 MOSFET
- 1 Cable
Double - 2 MOSFET
- 2 Cables
- 2 Nozzles 0.4mm for wire of 1.75mm
2 x Heated bed power module with cable