We are now proud to present our latest development, DDG Extruder for Ultimaker2 that feeds filament without grinding and with a very firm grip of the filament that will allow for faster printing without under-extrusion problems and also high retraction prints like Voroni models without grinding.
- Strong housing parts in SLS Nylon in black colour
- Bondtech precision cnc machined gears in hardend steel.
- New driveshaft in cnc machined stainless steel
- New bearings
Parts re-used from Ultimaker 2+ Feeder
- Big plastic gear
- Pushfit connector + bowden clip
- Screws (4x M3x16)
- Filament inlet guide
- Compression spring assembly
This extruder re-uses parts from the Ultimaker2+ feeder (Used on Ultimaker 2+, Ultimaker 2+ Extended, Ultimaker 3, Ultimaker 3 Extended)
So if you do not have an Ultimaker 2+ feeder you will not be able to use this extruder
The original stepper motor of the printer will be reused and the extruder will be mounted at the same position and in the same mounting holes as the factory extruder making the installation easy and fast.
Installs in about 20 minutes.
E-steps needs to be updated to 311
Firmware available for Ultimaker 2, Ultimaker 2 Extended, Ultimaker2+, Ultimaker2+ Extended.
This extruder is developed toghether with C.Matthes in Germany
For documentation: www.bondtech.se/docs