This Kit is designed for Delta 3D Printer (integrated thermal solution),have hexagon shape,
perfect fit frame at the bottom of the printer, compatible with a short aluminum 24cm Delta model,
using high temperature glass fiber wires to eliminate wires and heat aging for a long time,
as well as perimeter insulation falling off cause a short circuit,
heating and thermal wire is soldered and have 2pin Horn head, Plug and play.
With auxiliary power switch power supply, using the pluggable terminal blocks,
insert Makeboard matching Control Board can be used easily and quickly.
Using glass fiber material, non-aluminum panels, double-sided copper-clad and are black, and suit Micromake 3D Printer styles we sell here. Good design positioning hole, include supporting fixture, black crystal plate will be fixed directly on the hot bed, do noit need to use of long tail clip.
Circle diameter: 200mm
How to use: Shown below, the power cable, DC cable access terminals corresponding to the position of the switching power supply
according to the specified color, do not exposed metal part of the wire!
Whenever installation, adjustment of switching power supply, be sure to remember to unplug the power, remember!
The white line connect to HEAT BED terminals, black temperature cable plug in THERM B socket.
Power red line above the black line. Remember tighten the screws.
1 x Heat Bed
1 x Switching power supply