MKS BASE V1.6 controller board

SKU
MKS BASE V1.6 controller board
0 In stock
DKK287.50 DKK230.00
-
+
MKS BASE V1.6 controller board is available to buy in increments of 1
Overview
MKS BASE V1.6 controller board
Sold By
Footwear Store
0 / 5
Something missing?

Something out of stock or missing?

Please don't hesitate to contact us


Vi er en kreditværdig virksomhed baseret på Bisnodes kreditvurderingssystem. Vurderingen er foretaget ud fra en mængde forskellige beslutningsregler. Oplysningerne bliver opdateret dagligt via Bisnodes database. Kreditvurderingen af virksomheden er således altid aktuel.

Descriptions:

- This is the combination of MEGA2560 + RAMPS1.4 + 5 x A4982 drivers (remix board)
- Firmware can use the same configuration as RAMPS1.4
- It is suitable for dual-Extrude printer
- Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on  board
- 3x temperature ADC connectors for thermistors
- Up to 5 motor drivers with A4982
- 4x PWM capable power mosfet outputs  with voltage selector for MainPower.(Bed, Extruder0,  Extruder1, Fans)
- 4 layers PCB, optimize heat dissipation.
- 6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
- Recoverable fuse for short-circuit protection.
- USB Driver Chip FT232RL, you can get files from ftdichip to setup driver: Ftdi-x86.zip


Package included:

1 x Control Board

MKS Base V1.5 3D Printer Control Board With USB Mega 2560 R3 Motherboard Compatible With RepRap Ramps1.4

MKS Base V1.5 3D Printer Control Board With USB Mega 2560 R3 Motherboard Compatible With RepRap Ramps1.4

MKS Base V1.5 3D Printer Control Board With USB Mega 2560 R3 Motherboard Compatible With RepRap Ramps1.4
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account