MKS-GEN L V1.0 Integrated Controller Mainboard + 2.8 Inch MKS-TFT28 For 3D Printer

More Views

MKS-GEN L V1.0 Integrated Controller Mainboard + 2.8 Inch MKS-TFT28 For 3D Printer
Excl. Tax: $85.07 Incl. Tax: $106.34

Availability: Available to order

Delivery time 1 - 2 weeks

MKS-GEN L V1.0 Integrated Controller Mainboard + 2.8 Inch MKS-TFT28 For 3D Printer



Aiming at the problems exist on the open sourced controller board such as Ramps 1.4, the developers in Makerbase specially optimize and develop a new product, MKS-Gen L, which provides more flexible choices for users.

1. 2560 and Ramps 1.4 are integrated in the board, which avoids the complicated connectors.

2. Support a variety of stepper drivers such as A4988, DRV8825, TMC2100 and LV8729, available to change the stepper drivers and motors as users like.
3. Reserve external driver signal, available to connect external high-current driver to drive the 57 and 86 stepper motors.
4. Use high-quality MOSFET, better cooling and more stable.
5. Use specific power chip, support 12V-24V power input, and resolve the problems of chip heating and power shortage.
6. Stable and reliable filter circuit greatly reduces interference and avoids crashes as possible in the process of printing.
7. Use CH340 serial port chip, more easily install the drive than 16U2.
8. Run Marlin firmware, the configuration is completely same as Ramps 1.4, and available to directly replace the Ramps 1.4.
9. Support Ramps 1.4, 2004LCD,12864LCD, TFT28 and TFT32.
10. Available to input 24V, the heated bed current can be reduced to 1/4 at the same system power which effectively resolves the problem that the MOSFET of heated bed heats.
11. X axis, Y axis and Z axis with different color terminal controls the stepper motors and endstops, which is convenient to wire.
12. Plug the stepper drivers according to the different color terminals which decreases the  probability of reverse and prevents the controller board damage.

MKS-TFT28 Touch Screen


- 2.8-inch color touchscreen, support U disk, and SD card.
- Reserve WIFI interface, support WIFI function by adding WIFI module.
Three themes, two styles, provide the users with more choices.
Allowed to self-design the interface of booting logo and all buttons.
Allowed to add at most 13 customized function buttons.
Update the configuration and firmware by SD card, easily operate.
Support Marlin, Repetier and Smoothieware firmware, and don’t need to modify the master program.
Allowed to work with Ramps 1.4(TFT28) as well as controller board developed by Maker base.
Support “print from breakpoint” function,“print from power outage” and “filament detect” function.
Support “auto off after printing finishes” function with “auto off after printing finishes” module.

Package Included:

1x MKS-Gen L V1.0 board
1x MKS-TFT28 touch screen
1x USB cable
1x FC flat cable

System connection diagram:
Installation Dimensional Drawing:
PIN port map:

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

This site uses cookies. By continuing to browse this site you are agreeing to our use of cookies. Find out more here.