1. It gather 2560 and ramps1.4 on a same board, which solved the Ramps1.4 combination interface problem that easily out of order.
2. Can replace the motor driver, support 4988 drivers and 8825 drivers
3. Circuit board uses the high quality of 4 layer board,optimize heat dissipation;Ramp Is 2 layer board
4. Using special power supply chip, support the 12v-24v power input, solve the problem of Ramps voltage conversion of chip fever.
5. Accept 24V input, under the same system power can reduce the current hot bed to 1/4, effectively solve the problem of hot bed MOS tube heating
6. The firmware can use open source firmware Marlin, configuration are exactly the same with ramps1.4 , can be directly replace ramps1.4 also
Can be connected directly to Ramps1.4, 2004 LCD control board and the LCD board (12864)
7. Provide three 5V output, three 12V-24V output interface.MKS-TFT28 Touch ScreenFeatures:
- 2.8-inch color touchscreen, support U disk, and SD card.
- Reserve WIFI interface, support WIFI function by adding WIFI module.
- Three themes, two styles, provide the users with more choices.
- Allowed to self-design the interface of booting logo and all buttons.
- Allowed to add at most 13 customized function buttons.
- Update the configuration and firmware by SD card, easily operate.
- Support Marlin, Repetier and Smoothieware firmware, and don’t need to modify the master program.
- Allowed to work with Ramps 1.4(TFT28) as well as controller board developed by Maker base.
- Support “print from breakpoint” function,“print from power outage” and “filament detect” function.
- Support “auto off after printing finishes” function with “auto off after printing finishes” module.Package Included:
1x MKS-GEN V1.4 mainboard
1x MKS-TFT28 touch screen
1x USB cable
1x FC flat cable