USB type B receptacle.
SD Card add on available.
Fits 5 Pololu stepper driver board.
LEDs indicate when heater outputs on.
Expandable to control other accessories.
Heated bed control with additional 11A fuse.
Option to connect 2 motors to Z for Prusa Mendel.
I2C and SPI pins left available for future expansion.
It has provisions for the cartesian robot and extruder.
All the Mosfets are hooked into PWM pins for versatility.
3 mosfets for heater / fan outputs and 3 thermistor circuits.
Fused at 5A for additional safety and component protection.
Pololu boards are on pin header sockets so they can be replaced easily or removed for use in future designs.
Servo style connectors are used to connect to the endstops, motors, and leds. These connectors are gold plated, rated for 3A, very compact, and globally available.
Pulley teeth: 20
Pulley bore: 5mm (NEMA 17 shaft size)
Pulley material: Aluminum
Belt wide: 6mm
Belt pitch: 2mm
Belt material: Fiberglass reinforced rubber
1 x Ramps 1.4 board
1 x Meage 2560 for Arduion
1 x Mk2b heat bed
1 x 12864 LCD Screen
3 x endstop
5 x A4988 motor driver
1 x 1 meter gt2 belt
2 x 20 tooth Pulley
1 x 12v 40w Heater Reparap Cartridge
1 x 100k ohm NTC 3950 Thermistors with cable
1 x USB cable
1 x Smart Adapter
2 x FC Flat Cable
1. Please allow 1-3mm error due to manual measurement. pls make sure you do not mind before you bid.
2. Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!